Hello, I have a problem about M30 function. I use FEELER CNC with Fanuc Oi mate MB Controller. At the end of the program, I used M02 and everything worked just fine. However, when I tried to use M30, everything came to a halt and I had to restart the machine all over again. Please advise me on what I did wrong or what I could do to fix this problem. Thanks in advance.
pmanoj
Thread: Problem with M30
Results 1 to 1 of 1
-
10-13-2016, 05:17 AM #1
Registered
- Join Date
- Jul 2013
- Posts
- 16
Problem with M30
Reply With QuoteSimilar Threads
-
Fadal Idler problem. Rpm pulse problem
By complextool in forum FadalReplies: 1Last Post: 10-07-2016, 06:28 PM -
Tube problem or powersupply problem? Help you to check out
By Melody-gweike in forum Laser Engraving / Cutting Machine General TopicsReplies: 0Last Post: 10-05-2012, 04:09 AM -
daewoo puma 12lb tape format problem/parameter problem
By robb12877 in forum Daewoo/DoosanReplies: 0Last Post: 08-25-2011, 06:13 AM -
Surface finish problem - Could you please help me overcome this problem?
By DMBGO in forum EMCO LatheReplies: 5Last Post: 08-04-2010, 11:33 PM -
machine problem or software problem?
By bcnc in forum Syil ProductsReplies: 8Last Post: 10-26-2009, 03:51 PM
Tags for this Thread
Posting Permissions
