To Load a program(That is already on the machine/hard drive)

1. Make sure Key is set to "Edit/Comm"
2. Press "Communication" button on right hand side
3. Press "Data I/O" button
4. Press "NC - Disk" button
5. Move up/down the folders to the correct folder, press "Input" button on correct folder
6. Move cursor over the correct MPF file you wish to load
7. Press "Load Start" button, if it comes up with do you want to overwrite, press "yes" button
8. Press "Machine" button
9. Turn Mode/select dial to "Auto"
10. Press "Select Program" button
11. Scroll down to correct folder name
12. Type in program number e.g MPF7
13. Press "Select program" button again
14. Press "Edit program" button, check program is the correct program loaded