Transfer a program to the lathe from a pc

1. Press "Communication" button
2. Press "Data I/O" button
3. Press "Data Input" button
4. Scroll down to USER using
5. Press "Input" button
6. Scroll down to LOCAL
7. Press "Input" button
8. Scroll down to the folder you wish to transfer program into
9. Press "Input" button
10. Make sure cursor is over the line with all the dots
11. Press "Input Start" button, then press "Ok" or "Send Data" on your PC program

I've normally used Hyundai's D-Pro software to write programs & transfer them. I have also used Gibbcam & HyperTerminal as well