[ryan99yz]

I use the tool table and I'm setting each tool individually. I have had previous problems with, not tightening the collet enough allowing the endmill to slide up into the holder, not tightening the vice enough allowing the piece to move, tightening the vice too much bending the piece (derlin) etc. I've finally had some success with annealed W2, just can't seem to figure out how to cut the bevels.

My next idea is to cut out the blank of the blade so the endmill can enter from the side, does that make sense?

[joshetect]

I havent watched this yet, but I'm sure this will have some good tips
https://www.youtube.com/watch?v=I3uP8QzfJJ8