I have recently aquired a Morbidelli Author 502 for an introduction to CNC routers, as a novice I urgently need an opporating manual and any other info I can get.
I have had no luck searching the internet.
Any info would be greatly appreciated.
I have recently aquired a Morbidelli Author 502 for an introduction to CNC routers, as a novice I urgently need an opporating manual and any other info I can get.
I have had no luck searching the internet.
Any info would be greatly appreciated.
These types of machines are very complex, even for experienced users. And their manuals are typically more of a reference, than instructions on their use. And typically rather cryptic, vague, or both.
You're best bet would be to call Morbidelli and order any manuals, if they're still available.
And most likely, you'll really need some training. I'd see if there's a local technician that may be able to help you out.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I have 2 Author 502's and about 12 years experience so I might be able to help you.
@gtir - Could you please write (briefly, but include some details) about the process of programming, setting up, and operating your routers? Maybe include some screen shots or photos and sample code? This subject came up recently in forums and it has been so long since I worked with a Morbidelli that I really could not recall any useful information. - Thanks in advance.
It's a while since I was on the forum, so I've only just seen this.
I may be able to help.
Until recently I had an Author 502 & I now have a U550, but I still have access to the 502 manuals.
I am in the northern suburbs of Brisbane.
I have facilities for scanning to pdf file.
YOU may be able to help me buy sending me scaned pdf file of morbidelli 502
THANK YOU
Tis is a very very old request & you may have given up or found what you want.
Maybe I can still help
Hi All,
I know that this is now a really really old thread,
I recently purchased a 502 and are looking for a manual as danarch was.
How did you get?
Greg do you still have access to the manual?
Cheers,
Ross
Yeah, another necropost for this thread. I am also in need of a service manual for Author 502. In fact, any kind of documentation would be useful.
Ross_NZ, how did you get on?
Hi IBacon,
beeonline can help with the manual.
I think you may be able to PM me & I will give you an email.
If not, we will make other arrangements.
regards
Greg
are you still with the morbidelli author 502? I have an author 502 which have the Z axis moving out of zone. I would greatly appreciate and is willing to pay the right fee for good advice to fix the issue
I have the manuals in my office in Melbourne. Quite thick books, not sure how to share
Hi, I am Tom. I also have a Morbidelli Author 502 and I would appreciate if you could help me with the 502 pdf manuals if you still have them.
Many thanks.
Tom