[Ozemale6t9]

Straight out of the Dataserver operators manual:-

1.7 DNC OPERATION
You can drive the DNC operation by using the NC program
in the HDD.
Procedure
(1) Change the mode of CNC into “RMT” mode.
(2) Display the screen of “1.3.1 Display the table of NC
programs”.
So, “DNC FILE NAME” is displayed on the right and high
of the screen.
(1) Input an O-number of the NC program that you will use
with the DNC operation and press the INPUT function
key.
(2) An O-number of the NC program is displayed on the right
and high of the screen.
(3) Start driving the DNC operation with the cycle start
switch.

See attachment for dataserver dnc screen

NOTE
1 You must set “5” on the NC parameter of I/O Channel
(No.0020) in order to use this function.
2 You can not execute this function together with “1.4
CALLING A SUBPROGRAM WITH M198”, “1.5
REGISTERING A NC PROGRAM” or “1.6 OUTPUTTING
A NC PROGRAM”.

regards, Oz