[Junaidzia]

I am new to milling pvc foam sheet.
When i cut from inside while profiling i am getting good finish on waste but on sheet.
When i cut from out side i getting finish left over sheet.
I want to reverse this plz suggest what should i do.


Sent from my Redmi Note 3 using Tapatalk

[esmiller]

OK.. My first thought (I have been away from the game for awhile, so i could be remembering this wrong) is that the best bet is to change the direction of your cut. This depends on the software you are using. One direction is Conventional (Going Clockwise) the Other is termed Climb cut where it is cutting Counter-Clockwise.
Reversing the direction of your cut should (I think) affect the tearoff from your bit.

Eddie