Just a quickie - the tool table.
Really easy to get in a mess i think here so i want to get it good from the off.
If i enter a spindle speed of say 4000rpm and a chip load of say 0.0254mm for a tool, fusion populates the rest with seemingly good figures to start with.
However, does its F&S calculations go deep enough to vary F&S if i increase or decrease engagement or depth of cut etc in the operation stage???
Just trying to figure out how i can populate the library with meaningful data to save time if there are so many options and cut strategies etc - HSM, 3d, 2d, facing so on.
Seems the library is pretty much key to a lot of time saving or wasting so i want to get this area right i think.
Thanks