[jsnsykes]

jsnsykes, The board is marked:

HONCAR HBLC-1100-300H-S008(A)
Powermainboard
VER 1.0 2012.05.18

I'd also be really curious as to what route you will be taking with your machine. Again, total noob here, but aren't motors and such available here in the states that could be replacements for yours?

Thanks for the reply.

CE

Yes, many options are available. I will likely fix my issues with the spindle board by bypassing the interlock, or dumbing it down somehow, and get a centroid acorn board to handle the rest. Thus upgrading the entire system, and putting one more step between myself and my reliance on Syil to help (because they dont/cant)

Sent from my SM-G900V using Tapatalk

[lockbuilder]

Yes, many options are available. I will likely fix my issues with the spindle board by bypassing the interlock, or dumbing it down somehow, and get a centroid acorn board to handle the rest. Thus upgrading the entire system, and putting one more step between myself and my reliance on Syil to help (because they dont/cant)

Sent from my SM-G900V using Tapatalk

So the Acorn board doesn't control the spindle right? It just has the 0-10 volt output for the spindle driver you choose. Do I have that right? So even if I went with an Acorn control, I'd still have to get myself a spindle controller.

Also, what is an interlock?

It would be cool if I could just find a spindle controller that was compatible with the rest of the Syil electronics, I just have no clue how to figure that out.

Again thank you,

CE