Made a part, you can see what it is supposed to look like in first picture, then created the toolpath for it.
For some reason, it is not running Toolpath lines 26 and 28 in the simulation (picture 2)
Those lines are highlighted pink for some reason.
The Part is symmetrical, and I even double checked by going back, splitting the sketch down the middle and Mirroring the side that the Toolpath worked on, then extruded the part again, created a new toolpath, but had same problem.
Am I missing something blatantly obvious?
Sorry for the simple questions, but I haven't done this in a couple of years so forgot a lot, and even then I was quite a beginner.
Appreciate the help