Re: Quick Question / Clarification on G54
Originally Posted by
dregalia
So, G54 would take me to said offset... G10 modifies the coordinates,
Lets assume inches on the spacing
so.. if I had G10 X.625 in one line
And then I ran the code G0 X.725, it would move the X axis .1 inches... right?
Ultimately, this is the behavior I'm looking for.
I think that's correct. Where do you apply the tool offsets? I normally use a G53 (ACS) for tool change clearance, and a G54 (WCS) where the tool offsets are applied for turning.
Jim Dawson
Sandy, Oregon, USA