hi,
For Hurco BMC30 (ultimax II ) you need to output absolute arc center (i,j control dosen't recocnize 'R' ) and just add G75 in start block and end programme with 'E'
Javed
Thread: Hurco BMC20 Post Prosser help
Results 1 to 13 of 13
Hybrid View
-
11-25-2006, 04:27 PM #1
Registered
- Join Date
- Nov 2006
- Posts
- 14
post processor for Hurco--- solution
-
12-02-2006, 11:52 PM #2
Registered
- Join Date
- Apr 2005
- Posts
- 52
I run a VMX30 and it was a shock to me also, with the hurco bmc code the drilling cycle has all positive Z's and no R plane but you can have an extra Z ahead of the peck Z that acts as a first peck and return point? very strange.I got my boss to get the ISNC softwear for the machine that will make it act just like a fanuc control
so I can post right from mcam.
Forrey
-
02-04-2007, 12:49 AM #3
Registered
- Join Date
- Feb 2007
- Posts
- 3
hurco post for gibbs?
So does anyone know if there is a Hurco max 32 post for gibbs?
-
02-04-2007, 10:44 AM #4
Registered
- Join Date
- Dec 2006
- Posts
- 406
I've been running a BMC 30 for about 4 years. It has a
ultimax3 control. If your machine has conversational control I would use that for drilling and tapping. Just tell
the control where the holes are how deep to drill and what the peck depth is. Also tell it the tool info. With the
hurco I only use G-code for 3d contouring. If you have
the conversational and set it up right I find it lowers
cycle times quite a bit.
Reply With Quote
Posting Permissions
