ports and pins > Output pins.
ports and pins > Output pins.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Here is what I have for the output
Attachment 405962
I used a relatively low pwm base frequency because i use a microcontroller to read this signal. You might use a higher frequency
........select minimum pwm as 0
basically use my settings as a starting point
And if the voltage is changing, but the VFD is not, then you're VFD settings are wrong. Check PD001 and PD002. There's also a jumper that needs to be set correctly.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)