[ianagos]

Is the voltage going into the drive correct? 230-240v no higher? Also seem like low ohms on the resistor? But may be correct I dont remember. Is there a fuse in the drive for the regen circuit? Also if that was the only thing wrong with the baldor drive glentek sells a add on unit for breaking for about $400.

[destroyer125]

Is the voltage going into the drive correct? 230-240v no higher? Also seem like low ohms on the resistor? But may be correct I dont remember. Is there a fuse in the drive for the regen circuit? Also if that was the only thing wrong with the baldor drive glentek sells a add on unit for breaking for about $400.

The voltage is correct. I have two 13ohm regen resistors so it should ohm out to around half that. 7 Should be good.

Sounds like you don't have it set for dynamic braking so the braking resistors are not turning on, or maybe the decel is set too short.

I don't have a Glentek manual, do you have a link to yours?

This is the only manual I have:
https://itscnc.com/images/Glentek%20...%20SMB9675.pdf