Originally Posted by
diarmaid
Ok Im checking my Y wires now, but I still dont know why X and wont turn....
Don't worry, I am sure the answer is right in front of you.
You can also try Kcam and Turbocnc if you just want to see them do a quick jog, they are a little less confusing to set up.
Really the best thing to do would be to print out the setup instructions for Mach, and read them while you are "away". I bet there is something small I am forgetting, and just don't remember. .
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
"If the women don't find you handsome, they should at least find you handy"
-RedGreen show.