Re: 770M Initial impressions
Originally Posted by
MichaelHenry
Every once in a while I check simulated times to machine a part using SprutCAM, which defaults to 500 ipm rapid speeds instead of the actual speed (120 ipm?). The difference in estimated total job time between 500 ipm and 120 ipm is usually not enough for me to be concerned. I'm manually changing tools and usually running 10 parts on less on a job, though. Watching the Tormach rapids sure seems like a lot slower at times, though.
Yes, I find there is minimal difference in SprutCAM times and actual times even when running multiple tools with a 30min run time using ATCs. I think the biggest time savings will be tool change time.
RAD. Yes those are my initials. Idea, design, build, use. It never ends.
PCNC1100 Series II, w/S3 upgrade, PDB, ATC & 4th's, PCNC1100 Series II, 4th