Re: Toronto - Fusion 360 Beginner Help
Hi guys,
I am no where near you but am also a newbee to Fusion 360. I struggled to get the basics but then ran across a couple of YouTube sites that have helped me immensely.
The first is Paul McWhorter who is a teacher out in New Mexico I think. Anyhow he has done an excellent series on getting Fusion 360 up and running. While most is geared towards 3D printing, but basics are the same and he is an excellent teacher.
https://www.youtube.com/channel/UCfY...ZTpNFrc_NDKfTA
The other one that I enjoy on YouTube is Lars Christensen who does a live stream most work days at 3PM and on Wed. evenings at about 8PM eastern time, he has a Facebook live stream that is dedicated to beginners and will stop and answer questions submitted. These broadcasts are then posted up on YouTube usually over the following weekend.
https://www.youtube.com/user/cadcamstuff
I am not sure of the Facebook url, as I don't use it, but he mentions it in his videos.
Hope this may help you.
Art
AKA Country Bubba (Older Than Dirt)