[JohnTC]

Im getting an PG parameter Error with the above settings
"Quote from manual"
Cn-45 and Cn-46 must meet the following relationship:
2 * Cn-45 * Cn-02 / Cn-46
?If not, an error message “Input Error” will be displayed

Help

[mactec54]

Im getting an PG parameter Error with the above settings
"Quote from manual"
Cn-45 and Cn-46 must meet the following relationship:
2 * Cn-45 * Cn-02 / Cn-46
?If not, an error message “Input Error” will be displayed

Help

That's the spindle RPM

The CN46=2 for your 2 Pole motor

CN02=400 which is correct

So CN-46 has to match the spindle RPM 24000 I'm not sure if it can accept 24000

So CN-46=24000 Not 2400 should correct this