[Heavy_Metal]

Hi toranacar,

All standard (iso) nc-code can copied to CimcoEdit, when you backplot (simulation) the code it becomes "visible".
You can use Cimco for DNC, but large programs by f.e. Mastercam can cause buffer problems on control side.

Regards,
Heavy_Metal.

[toranacar]

Hi toranacar,

All standard (iso) nc-code can copied to CimcoEdit, when you backplot (simulation) the code it becomes "visible".
You can use Cimco for DNC, but large programs by f.e. Mastercam can cause buffer problems on control side.

Regards,
Heavy_Metal.

So the buffer issue can be resolved by editing in cimco or is it because my controller is old and lacking memory?

[Heavy_Metal]

Hi toranacar,

It's controls memory and buffer clearance but also RS232 speed can causes problems, not CimcoEdit.
3D milling are tons of lines which can be a problem for older controls.

Regards,
Heavy_Metal.

[toranacar]

No worries. I hope I don't get too many issues like this as the cnc will be coming soon.