[SWATH]

Awesome. Nice job on the overhaul.

Especially as I have 4x DMM 750's waiting to get stuffed in my 1610L pretty shortly. I'm upgrading the controller & spindle (againg) at the same time so it'll be a total retrofit.

The blue coils at the top of your electrical enclosure... line reactors? You find them necessary, or are just going by the 'optional' in the DMM manual and seemed like a good idea?

Also, the green breakout boards for the servos... source? They look handy.

Thanks! Nice! What spindle are you upgrading too? BT30? What controller?

Yes those are line reactors, I spoke with DMM throughout the entire build process and they recommended line reactors.

I have two breakout board types I'm using there. One type are 2x8 pin header breakout boards so I can use the the same cables that connected to the previous stepper drivers to the Mikini front panel. The other type are just DB25 breakout boards. I found them both on Amazon. I think I just found the cheapest ones. I also bought some DIN rail mounts so I could just mount them to DIN rails. I actually have the DMM breakout board but was unable to get the Mikini DIR signals to work correctly to change the motor direction. So ultimately I just built my own breakout using four DB25 breakout boards.

DB25 breakout boards: https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

2x8 pin header breakout boards: https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

Extra DIN rail mounts (if needed): https://www.amazon.com/Sysly-Mountin...9S7KDRD1VX8KZN