Originally Posted by
Mauri R
Trung,
I tried another test, just doing the holes and slot but not the cubes.
Voxel=.14 and no display of anything but the stock and it displays OK in simulation.
Try it and let us know.
The simpler the simulation the more you have to play with the settings.
Also did a just holes version with Voxel=.14, however I have to select this setting twice to make it display correctly.
Voxel=.14 is the lowest it will accept with this display.
Tried just the Cube with small hole Voxel=0.01 to 0.06 all OK except for the centre spigot in the display.
Again only the stock was selected in the simulation.
Tried just the cube with the Big hole it picked Voxel=.06 all displayed OK, however it takes a long time.
Again only the stock was selected in the simulation.
So by selecting to display the cutter in simulation that's when issues occur.
I have found another issue, if you just select the large cube with only the stock clicked when you look at the Voxel it always selects .06, if you change it upwards to 1.0 it makes not difference it is as slow as .06 and displays correctly the same as .06.
Once you redo, while in simulator and select a large number then the display quickens but looks rough.
Changing it lower down to .06 while still in the simulator make not difference until you relaunch the simulator.
It seems to pick the initial setting and will not change it until it is out of some limit set in the program.
Not sure what is going on, only Joakim can work this one out for us.
This is enough from me.
Regards,
Mauri.