[TheFabricator03]

TheFabricator03, thats really interesting. How thick is that material and how far did it warp? And did the plasmac config control the torch height under those conditions well?

rodw,

That material that warped was 16mm thick. It roughly warped up about 40mm and yes PlasmaC's integrated torch height control handled it with out any drama. I have cut everything from 1.6mm sheet to 25mm thick plate with out any problems.

I cannot speak highly enough of the development. Even the learning curve to get Linux set up was not too difficult. I find it very stable and easy to use.