Hello everyone.
I need a manual for VFD ZONCN NZ200.
I wrote to the supplier. I wrote to the manufacturer and no one answered me.
Can you help me please?
Thanks Jirka
Hello everyone.
I need a manual for VFD ZONCN NZ200.
I wrote to the supplier. I wrote to the manufacturer and no one answered me.
Can you help me please?
Thanks Jirka
ZONCN
Thanks
Hello.
I need to set - "device error" for relay output 1.
Set to relay output 2 - "device on" output
For analog output I need to set - output "Current frequency" - 0-10V.
But it probably doesn't have an analog VDF output.
Thank you
Next, I need to set to control the pump power with an external potentiometer.
Hi.
"And no you would not use any of the relay output for a Pot" (I don't understand this sentence)
VFD is used to control the vacuum pump power for the vacuum table. I need to adjust the power with a potentiometer. When milling holes and grooves I need to increase performance. I meant to connect the potentiometer and pressure sensor in series.
Thanks
Mactec54
Do you need to controll the VFD dynamically?Then you need a controller which has analog input and output module. Such as PLC.
The potentiometer and pressure sensor connect to the controller's input terminals, and its output terminal connect to the VFD‘s analog input terminals.
Please send it to [email protected]. Max. 20Mb.
Thanks
Jirka
Mactec54