Hi,
I'm new to the group and unfortunately I have to ask for something immediately.
We need the parameters for a 1993 Leadwell MCV-OP with Fanuc OMF. Can someone please help and post them ?
We are a non-profit makerspace that mentors high school students in robotics, mechanical design, electronics, welding, 3d printing, etc. Our makerspace is member funded and as a result, have very little money for cnc machines, stock , screws, metrology, tooling, etc..
We found the Leadwell in a ditch by the side of a road and thought it was terrible to see it scrapped. We found out it was purchased at an auction, sat in a barn for 8 years and dragged to the ditch using a underpowered forklift, damaging the cable in the ways, smashing the oil pump to bits, shattering x-axis servo connectors and resolver cover. Did I mention is was covered with bird droppings ? Fortunately the controller box was immaculately clean on the inside and we did get the wiring manual... We repaired all physical damage could find, but the oil pump; and cleaned the bird droppings... .
It was powered on for the first time Saturday and have a 910 parity error. The backup batteries were completely dead, so we're assuming we need to reload the parameters.
I'm trying to attach the displayed parity error.
Any help would be appreciated..
Also, can anyone tell us what the mini-cassette next to the memory board is used for ?
Thank you,
GaryM