Backlash shouldn't be the issue, I do have .001" on each axis, but have backlash compensation on in Mach3. My manual programming yields no issues with backlash. My Madcam post shouldn't turn off backlash compensation?
Backlash shouldn't be the issue, I do have .001" on each axis, but have backlash compensation on in Mach3. My manual programming yields no issues with backlash. My Madcam post shouldn't turn off backlash compensation?
Here is the gcode in attachment. I used this to skim the part .002" to see if the cut quality was better. Finish turned out exactly like original