With the 29-11 update, the buttons for activating / deactivating the refrigerant and the fog no longer work (M7, M8 and M9 still work); the buttons activate / deactivate the full screen mode instead of the outputs.
With the 29-11 update, the buttons for activating / deactivating the refrigerant and the fog no longer work (M7, M8 and M9 still work); the buttons activate / deactivate the full screen mode instead of the outputs.
Ups, I published wrong files. I was testing full screen mode and I temporary assigned it to mist and flood toolbar buttons.
I will repackage and upload correct version in few minutes.
Ok, it happens when you work too much ... :-)
Thanks
How true
It should be fine now. Fingers crossed :-)
Hi,
I downloaded the zip this morning (for Windows) and ran the update again but unfortunately the bug is still present.
Attachment 432156 Attachment 432154
It is possible that installer did not replace files because they have same version number.
Replace .exe and both dlls with these:
https://planet-cnc.com/wp-content/up...2019-11-29.zip
You're right, replacing the files manually, everything is back in place.
Thanks