I'll have to wait until I get them next week...
I'll have to wait until I get them next week...
Finally got my ECI tool holders from eBay. All I can say is wow, $1,300 worth of holders for $350. Very slight usage if any.
As I suspected they use a 3/8" mounting bolt but they will fit onto a Tormach riser.
Other than plated hardware I really don't see any significant difference.
The one TBS-1460 that I measured was not parallel in Z & was off by 0.0045" while X was not perpendicular & was off by 0.0015". Better than the first Tormach holder I got, but Tormach sent me another one that was dead on.
The dimensions for the dovetail holders & shank type holders are that critical.
Maybe I'm expecting to much from these bore type holders but I don't think it's that tough to get the bore lined up with the axis.
Anyway, I got 2 other ECI holders with 5/8" bores that I will straighten out & open up to 3/4".
So if I were buying more holders I would go with the Tormach - free shipping & if it ain't right they'll send you another one...