Hi Everybody,
I'm looking for edge/corner finder (but I would be over the Moon with a center finder) macro/script for my Chinese engraving machine. Of course, its controller is Chinese as well (BL-USBMach3).
I have tried macros from youtube videos unfortunately, they didn't work.
I have bought Gerry 2010 screenset, it didn't work even with his Chinese macros.
However, the existing HiddenScript.m1s for the auto tool height works perfectly, see here and attached as well.
'chengdu xhc tec. probe z surface macro
FeedCurrent = GetOemDRO(818) 'Get the current settings, OEM DROs (818)=Feedrate DRO
ZCurrent = GetOemDro(802) 'OEM DROs (802)=Z DRO
GageH = GetOEMDRO(1001) 'OEMDRO(1001)=Gage Block Height
ZNew = ZCurrent - 300 'probe down 20 mm
Code "G90F200" 'slow feed rate to 100 MM/MIN
SetOemDRO(818,200)
Rem Code "G4 P1" 'Pause 1 second to give time to position probe plate
Code "G31 Z" &ZNew
While IsMoving()
Sleep(10)
Wend
Call SetDro (2,GageH) 'DRO(2)=Z DRO
FinalMove = GageH + 10
Code "G0 Z" &FinalMove
Code "F" &FeedCurrent 'restore starting feed rate
SetOemDRO(818,FeedCurrent)
Could someone help me please to modify this script or write a new based on this for the edge/corner/center finding?
Thank you in advance,
Kind Regards,
Robert