Thanks for the info cncsnw,

since im not 100% sure what you mean, lets see ... Acorn comes with external board that contains a few relays, is that what you call PLC? Now, only concern about that , how strong the power through those Acron relays can go for the coil? 600V AC or is there some kind of the signal wiring? I would asume that if I can get the motor going, with same PLC relays I could get the flood pump started, is that correct?
Overall I realize that other brand Mills that used Anilam Crusader M have pretty much the same setup as the one I'm working on, I just can't seem to find any wiring diagrams for it, it would sure make a life hell of a lot easier