Re: Help with Novusun NVUM V2 USB control card
Thanks Mac for chiming in.
If I have a license for both Mach3 & 4 does that make the board ok to use Craig? I have an industrial rated USB shielded cable I use now on my keyboard with my Mach4 machine and its fine.
My new machine will not have a spindle or VFD and because of a medical event in my life I have downsized a lot. You do what you need to do.
The other board I referenced above is sold by a US Distributor with US support, how is that not a good deal?
Our dear president has pissed off just about everyone in the world including our former allies. The Chinese who now make our pharmaceuticals and medical masks and other supplies are now our enemy, but wait.. now people are dying from a lack of those same supplies. Lets be friends again. Craig, they make all our computers, cell phones, tvs' and yes even MRI machines. etc and other electronics so how can a CNC control board be junk, just because its made in China?
BTW I am looking at the PMDX series and I may go that route because I would rather run Mach4.
Retired Master Electrician, HVAC/R Commercial. FLA Saturn 2 4x4 CNC Router Mach4 Kimber 1911 45ACP