I test the link and I can download it without problem.If you need the driver or software,I can send you privately too.
I test the link and I can download it without problem.If you need the driver or software,I can send you privately too.
Can you download the driver and software?
hello
yes, i can and i did it.
i updated driver as shown on YT movie but already have te same driver.
Unfortunately software still says about missing dong
I have Ezcad2.9.9 and It was working fine with windows 7. and Install Windows 10 64bit version and when software opening it's saying "Can not find dongle.demo state".
when i try to engrave it's saying "Current LMC Board is not for fiber Laser"
And parameter setting F3 hardware info showing "invalid board"
but i tried to work with windows 7 again (old hard drive) it was working file.I think problem with windows 10 64bit. installation issue.
Does anyone have Ezcad2.9.9 software and drivers for windows 10 64bit?
or any other solution for it?
Thank you
from Sri Lanka
The USB driver needs to be updated while the laser is connected and in the full on state, as the control card acts as the "dongle". If you are receiving a missing dongle message, it means that the computer is not seeing the laser. Check that your laser state is on and try again.
He, was d6wn36ad driver from your given link but i see it's not working. i am using windows 10. Please need your help.
Heelo Iaboni,what's the version of your software?How's your control board looks like?Could you send a picture?
please, send me driver and sofware of control board laser mark V1 for win xp. thank you very much