Hi,
That is incorrect, the programming port on Delta servos is IEEE1394. In the marketplace there are two wiring standards for theMost servo drives can be setup ( Programed ) by using a USB cable suited for the Servo Drive
IEEE1394 plug, one of which can damage the drive. I elected to buy a genuine accessory. Note also that I chose the USB-IEEE1394
which is more expensive, a simpler RS232-IEEE1394 will cost as little as $20.
Yep....real good....mind you they should be at 3-4 times the price.if you want a comparison Yaskawa is the number ( 1 )
Craig