At step B it wants a probe data file.
Here's a nonsense example
The gcode file: (A)
Code:
G00 X0 Y0
G01 X0 Y0 Z0 F100
X4
Y4
X0
Y0
M2
The probe data: (B)
Code:
0.000000 0.000000 0.000000
4.000000 0.000000 1.000000
4.000000 4.000000 1.000000
0.000000 4.000000 0.000000
The gcode file modified by gcode-ripper: (C)
Code:
( G-Code Modified by G-Code Ripper )
( by Scorch - 2013-2019 www.scorchworks.com )
G90 (set absolute distance mode)
G90.1 (set absolute distance mode for arc centers)
G17 (set active plane to XY)
G20 (set units to inches)
(G-Code Preamble)
(---------------------------------------------------------)
G0 X 0.0000 Y 0.0000
G1 Z 0.0000 F 100.00
G1 X 1.0000 Z 0.2500
G1 X 2.0000 Z 0.5000
G1 X 3.0000 Z 0.7500
G1 X 4.0000 Z 1.0000
G1 Y 1.0000
G1 Y 2.0000
G1 Y 3.0000
G1 Y 4.0000
G1 X 3.0000 Z 0.7500
G1 X 2.0000 Z 0.5000
G1 X 1.0000 Z 0.2500
G1 X 0.0000 Z 0.0000
G1 Y 3.0000
G1 Y 2.0000
G1 Y 1.0000
G1 Y 0.0000
(G-Code Postamble)
M2
As I mentioned earlier I'm not using gcode-ripper to generate the probe data file, so I can't explain that part.
Scorch will probably reply soon if he's still getting email notifications of this thread.