[FastFarmer]

I still would put mastercam up against fusion anyday.

The fact that I can't export the model after it's machined for a second op with out modifying it pisses me off, and you can't take measurements in certain environments.

Trouble is mastercam doesn't even compete with $70 per month.

Yeap, that's sort of my issue too. Once you go fusion toolpaths, your fusion forever with their fd3 format.

And something else that baffles me about the CAM market is while I've been shopping around , both edgecam and ZW3D haven't even respond to my inquiries. Do they even care about SMB or are they just fat cats ridding companies like Honda and living of upgrades?

Every time I ask Autodesk something... the response and support is nearly instantaneous.