Yeah, it sounds like your only hope is to find someone who has the same control - I haven't heard of that one...
Do the pieces of paper show the pinouts for the parallel port connection?
Definitely ask on the taigtools group, if anyone has this control they would be there.
Originally Posted by
hollyfeneht
Evening~ thank you for responding!
The control hardware is a stepmaster nc 4-axis le. I down loaded the mach 3 manual and all the vidoes but am still struggling. patience is a virtue im learning. The dealer was over the internet and he has since moved out on contact. He only sent me a few pieces of paper along with the machine and controller.
I just recently registered with the taigtools yahoo group and will do some more searching there, thank you.
I appreciate the assistance with the controller setup if you happen to have the same one.
thanks again~
Nick Carter
Largest resource on the web about Taig lathes and mills
www.cartertools.com