Quote Originally Posted by ger21 View Post
I think your steps/unit are wrong. What is the pitch of the screws? IF you have 5mm pitch screws, then the steps/unit would be 1600/5, or 320.

If the units are mm, then the acceleration is fine, and could maybe be even faster.
350mm/min is very slow, and should probably be set to 3000 or more.
im sorry didn't understand -> (What is the pitch of the screws?) what screws?


so her is the video: pay attention @ 1:10 first run, And second run @ 4:11

Even though the cut came out clean. I'm just concerned about what happen during the cut.

https://www.youtube.com/watch?v=d5Kji18c7DA