[mactec54]

Hello Mactec54,

if I understand the right thing, I definitely need a PWM to analog adapter between the Mainboard JP-3163B, which is then switched to the frequency inverter.
Is this correct?

Are you still checking the wiring of the frequency inverter MK100-2S1.5G-DK?

Is it possible that you can tell me what kind of PWM to analog adapter you used?

And can you please draw a short circuit diagram of how it must be clamped. I think that would help a lot.

Do you have the same CNC 6040 in use?

I'm from Germany and try to have good technical English :-)

Thanks raini

Your Main Board seems to have a 0-10v and Gnd, just check with a meter to see if it changes when you change the speed in your control there may be some settings to change in your control to make the output work or it may need 12v supply added where it has an input for 12v-32v this may be all you need

Do I have a 6040 No I do not, but this is a basic setup that all machines have which are almost all the same