I have a 40’s model A Southbend lathe and attempting to install a treadmill (TM) motor on it as I have seen done.
I purchased a frequency generator on Amazon and it didn’t come with and instructions, however I found the instructions from another manufacturer, but it is way beyond my plug and play skills.
I’ll post photos of the instructions below, one of the things the instructions talk about is setting the frequency for the motor, how would I find that out?
It also mentions turning the module on and setting various parameters, it is wired through the TM, are they referring to the TM on/off switch, or do I need to do the setup with an outside power source and after setup connect it back to the TM controller?
I connected the frequency controller exactly like I say one on the internet. And I cannot get the TM motor to fun. I connected a 18V DC directly to the TM and it runs.
Can someone give me some tips on getting this setup?
Thanks