RFQ Question (sort of)
I hope this is not TOO far out of line for this section.
I’ve kind of wandered in here from some of the DIY sections looking for
advice. I wanted to get some slide rail support blocks cut, drilled and
tapped. 2.5” x ¾ ‘ HDPE (I supply Material) blocks 2.5” Sq, ¾ hole
in center of face, ¼’ hole (¼” inboard from each edge) in each corner of face,
3/16” hole drilled & tapped in center of each edge, perpendicular to the
¾” hole in the face and sharing the same center axis lines (adjustment screws).
Quantity 12 ~ 15 (need 12, be good to have a couple of spares)
A local guy with a machine shop wanted over $100.00 USD
Is this price about on target or out of line?
I'm located in the NorthMetro section of Atlanta, Georgia (USA)
Thanks for the help.
Mike_L
When I was younger I thought I knew EVERYTHING,
NOW, the older I get the more I find out I don’t know!