How high is your table?
Why direct drive for servo.
You can use a belt and have the servo out the way.
How high is your table?
Why direct drive for servo.
You can use a belt and have the servo out the way.
7xCNC.com - CNC info for the minilathe (7x10, 7x12, 7x14, 7x16)
Table - working surface is now sitting at 735mm from ground.
I was thinking of direct drive so i don't have to make transmission with belt drive and that way i have one less variable to look after.
But yes i think best solution will be to make belt driving and move servomotor on column out of way.
Like this, but to flip servomotor around and add belt for driving