Can't raise the ceiling....or rather, i've realy done that...there is no more to give, and i'm still 20-30cm short....
I've been looking at making a sort of cam, but the amount of force worries me a bit. First of all there is a ring which pushes down on the pressurering on the spindle, this ring needs to be hold in place, which is done by the cylinder in the original setup. So i need to keep this in place somehow...with 4000kgf on the end of it :-/
I've attached some pictures of the testassembly i have at the moment...and where the pressure ring is that needs 4000kgf to push it about 10mm to disengage the tool...
Attachment 460300Attachment 460302