I have purchased one of these Sewing machine servo motor setups from Amazon
https://www.amazon.com/Mophorn-CS100...0GGWA5SZ2VCV0W
Does anyone have any info on how to wire this back into mach 3 it has a 0-5v input for the petal, how can I use the 0-10v with it? I know I can just restrict the voltage in mach, but I'd rather have the full 10v because I would think that it would give me more range. It has an option for a synchronizer, I dunno how to use the thing to tie back to my board. is the encoder built in to the motor?