Hello it's VM 40 yasnac i80
Hoffman year1995.
John I can't find PM can jou please contact me on my mail
[email protected]
Thanks
Hi SHAS 595
I have hitachi seiki vk45 vmc Ladder corrupted,No pack up and no YU YU software can you please help me([email protected])
Thanks
Hi DANCY
I have hitachi seiki vk45 vmc Ladder corrupted,No pack up and no YU YU software can you please help me([email protected])
Thanks
HI*I have a hitachi seiki vk45 vmc Ladder corrupted*and no backup and no softwarecan you please*help me
Hi John,
Please is possible to get your E-mail and phone details also.
Thanks Mike
This is my first post so please excuss me if i am doing it wrong.
We have a hs400 that we lost all software on, Is there anyone who can help with this that you guys are aware of? Any help would be appreciated!
Hello John,
I've sent you PM about my Hitachi Seiki HT-25G. It stucks on boot up.
Hello everyone,
We have a Hitachi Seiki HC400 with Fanuc 15M controller, 3 axis, 1 index axis, 2 changing pallets. RAM got completely corrupted, so we needed to clear it up completely.
We had a backup of the NC parameters and tool changing programs, but unfortunately lost the PMC/ PC parameters, including the Timers, Couters, Keep Relays, etc.
Does anyone has access to the same machine or to a backup of these parameters? That would be extremely helpfull.
Thanks.
I just sent you the PM.
Thanks.
Ivan.
Mr john plz send me your contact number and email address plz
i need your help my machine in problem
Thank you
Abhilash
[email protected]
Last edited by Abhilash9880; 07-03-2021 at 05:58 AM. Reason: So text missing
I could use some help too.
[email protected]
Hello
I have some problem with my machine.
I have a Hitachi Seiki HC400, M-16-2 Seicos controller in need of ladder diagram .
Here's hoping you might be able to assist me. [email protected]
Thanks for your time.
Hai John
We have 1 Hitachi Seiki CS 25 turning center, now we faced C axis problem, any way we are not using C axis,
The spindle act as a C axis. I request you to kindly share the C axis Bypass parameter.
If it is you have kindly send me through [email protected]