Re: X axis is off center
Originally Posted by
mactec54
No one was doubting what skill set you might have, those that post here don't have these skills, and there for your post is pointless, this does not help anyone but cause confusion
What you explained in your post would not help anyone the Zone is about helping not about you or what you can do
Mac, how things should be a normal is really your opinion for if they come from the top or bottom. I find shops that come from the bottom all over the place and states. some start that way and some use it on there second op when coming from raw stock or other reasons.
So stating that the rest do not have skills really!!. you do not know what these folks know or how long they have been doing this. Or even that the way they do things was how they were trained. I have had my share of apprentices and trained them my way. may not be everyone's standard but I speak of different ways besides mine.
I teach the same way in my Mastercam classes I show them the tools and go through projects and we talk about different ways to hols and attack the projects.
But enough how I work or train. you want help like I think you do. give advice you can even say really this is how I suggest you do it. but to basically call them dumb in this trade. not going to go here.
pleas all continue to share your know how and you opinions really helps all around.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .