Originally Posted by
A_Camera
OK, it is still a bit unclear. Try this:
Are you doing a two step probing? Fast probing (step 1) and then retract and slow probing (step 2) for better accuracy? Answer yes or no.
No one step then retracts.
Is it doing a retract after step one? Yes or no.
Yes
After that retract it moves down again and not stopping on touch? Yes or no.
No just one touch and retract and its ready, or should be.
If yes to all three then it sounds like you have a setting issue. It does not seem to retract far enough before it starts the second (I guess slower) probing, and it seems that though it touches the surface, it does not recognize the touch. It sounds like you have the zero configured somewhere below the probe, which is why it is crashing, it tries to move to that position. You say you cleared out ALL offsets. Maybe you cleared out one too many...?