[mountaindew]

I received my new stepper driver today, and that brings up another question before I install it.

Do the PA Settings have to be set the same way that the old driver's were set? (White on/off switches on the Blue plastic)

My old driver had numbers 2 and 6 turned OFF.

I'm guessing that I need to also turn OFF numbers 2 and 6 on my new driver?

I matched all the dip switches from old to new. Y and z drives were also the same. A axis driver was different and had a different leadshine driver also. I also used heat shrink tubing on the yellow 310 wire and the one next to it. They both had melting of insulation near connector.
Cleaned the wire ends and coated them with dialectric grease. Clamped into connector and checked for solid connection.