Hi ,
I've got a problem with Amada pega 357 punch turett,
Error e05 s-memory(low) parity error
I phone Amada and say me motherboard was died and 3 other cards for a total of 30000$ .
It's too much for my society.
Can you help me ?
Thanks
Hi ,
I've got a problem with Amada pega 357 punch turett,
Error e05 s-memory(low) parity error
I phone Amada and say me motherboard was died and 3 other cards for a total of 30000$ .
It's too much for my society.
Can you help me ?
Thanks
Give more info on the control please: photos help.
Hello ,
It's fanuc O4PC
If that help you for find my problem.
The boot screen is freeze with the error E05 , but i can do origin axis .
The machine is connect to old pc win95 on a box named "adr inc"
Thanks
Thanks. Although that control is essentially a Fanuc 0-C control, I am not familiar with the "Error e05 s-memory(low) parity error" that type of an alarm has always been a 'fatal' one: no machine operation could be done until the alarm was cleared.
Do you have a recent backup of the programs, parameters and diagnostics?
I was thinking 10/11/12 or 15A with the connection unit there. Some form of very early MMC or Front end interface hybrid.
Try to replace memory board only & after press+ cancel+ del button or del+rest. Hope you successfully boot O-C controller. My guess have any track is missed in memory board.
Hello i've got this program (in attachement), but i 'don't kown if are just maccro or pms parameter and maccro , it's chineese language for me
Today i have deleted memory , RESET + DELETE button at boot , the error is always here
I show you all the cards that Amada wants to sell to try to fix my machine.
How can i replace memory ? i dont 't know where it 'is.
Thanks for help me
The memory chips are soldered and also socketed on the MEM BOARD, (A16B-1212-0210) There are also various other chips on that board involved in the memory area; it's likely that the problem is on that board.
What country and city are you in?
If i remove the memory card (A16B-1212-0210) , i loose all machine parameters ? (PMC) ?
I am in France in "le Mans"
OK, I will see to have the memory card checked,
For the machine parameters, I found some old numbered paper tape, I think it's the parameters but I have no idea how to use the tape reader.
Hello ,
Always with my problem on my Fanuc 04C
I unplug the memorycard , clean and check it , i see nothing.
But when i plug it , i have a new screen error at boot.
I think the eprom slot 3 is died ? it's good ?
Where i can find the microprogram 0156 FC1C if my diagnostic it's correct.
You have lost all volatile data: parameters, programs, diagnostics etc.
Turn the control ON while holding RESET and DELETE buttons;the reload parameters and diagnostics.
Can you help me, boot (make backup) againt Parameter, PMC, DNC,.. for Pega 244 O4PC.
Thanks so much.
sure