Hi guys
So I finally got my Leadwell powered up after 2 and half years sitting around (I think this is the main cause??) and got some errors.
On first power up I had an EMG Alarm (Red LED) also flashing on screen said "not ready".
So I read on this forum try pushing and holding "rest and Delete" during power up. (I probably shouldn't have done that):drowning:
So now the alarm messages are,
Spindle trouble (Other red LED)
100 P/S Alarm
417 servo alarm X axis DGTL Param etc. Ill post pics.
I was told ill need to load Parameters back into the machine?????