[machinehop5]

Thank you,

All I had to do to your example code was change the tool numbers to the 4 digit style (T02 to T0202), and delete all of the H and D codes. After that I was able to run the file from memory, or drip feed directly.

...Oh, good to hear up and running for large programs.
Just a note about large programs over N9999 max blocks long with Dynapath 40-60m's. start renumbering N1 and so on. Also, when Editing you can Insert blocks using a Decimal Point.... (up to 3 place decimal if I remember correctly)

Enjoy