[TadejG87]

Yes it helped a lot ! Have you did the same thing for the outputs to turn on the vfd ?

I did not try with VFD. I would say it depends on the type of VFD, but the logic is the same. Novusun will not output any voltage to VFD. Voltage must come from external components, output port from Novusun will just connect that voltage to GND.

[infectedfpv26]

Well i bought and NVEM controller for a plasma table but there is a problem because the torch starts when the cnc is travelling to the next cut and the torch gets off before finishing the cut. its something strange for M03 AND M05 commands.

If any know how to fix the problem i do really appreciate any help on this.

Best regards